Shake / Vibration when shifting from 3rd to 4th gear (Please Help)
i have a 04 acura TL automatic. 83,000 miles when i accelerate from 3rd to 4th the car shakes and vibrates for a couple of seconds till it shifts, then its fine. its the only gear it does it in. iv taken it to many differnt shops and have gotten diff ansers from each one. they have told me it could be the wheels needing to be balanced others have said it needs a whole need a whole new transmission . .Sence then i have gotten the two front wheels balanced and it still does it. does anyone know whats going on or has this happen to anyone else PLEASE HELP
|
You could try replacing your 3rd & 4th pressure switches and doing a 3x3 flush of the transmission fluid. There's a thread on here somewhere about the pressure switches.
|
im just nervous if i flush the tranmission that it could possible couse me more problems. what are pressure switches and are they hard to change ?
|
OUCH... try not to drive it! Order the 3rd & 4th & get some redline ATF ...... ASAP
You wont cause any more issues with the flush, the damage is already done. But it is IMPERATIVE that you use Redline ATF Type F. You wore down the gears so much that any ATF with friction modifiers will just cause it to keep slipping (aka stuttering) Trust me, I come from this exact experience myself 3 painfull weeks ago. Oh yeah & for the threads...... SEARCH : "Racing ATF" & also "An Interesting Conversation" |
AHA FOUND THEM... Remember... the faster you do it, the less damage to your trans. If you put it off.... get ready for a new TRANNY
INTERESTING CONVERSATION ABOUT TRANSMISSION https://acurazine.com/forums/3g-tl-2004-2008-93/very-interesting-conversation-my-transmission-builder-tl-721508/ DIY CHANGING THIRD & FOURTH SWITCHES https://acurazine.com/forums/3g-tl-2004-2008-93/110-diy-guide-replacing-3rd-4th-gear-pressure-switch-3g-tl-2004-2006-a-729149/ RACING ATF https://acurazine.com/forums/3g-tl-performance-parts-modifications-112/racing-atf-764322/ |
First, look up the '04 TSB for your car concerning the engine damper, it is located under the engine near the firewall I believe. I think there is a fix as they modified it to stop what you are feeling.
|
It's the pressure switches and fluid. Search, this is one of the most talked about subjects on here.
|
I had the same problem on my 08 from 2nd to 3rd at low speeds. I was about to have the transmission replaced under warranty but they flushed it instead and I haven't had any problems since. Flushing shouldn't cause any other problems if it's done correctly.
|
Originally Posted by dssmith
(Post 12715995)
I had the same problem on my 08 from 2nd to 3rd at low speeds. I was about to have the transmission replaced under warranty but they flushed it instead and I haven't had any problems since. Flushing shouldn't cause any other problems if it's done correctly.
|
Ok so tomorrow im starting w a tranny flush. if that does not work im going to change the pressure switches. Any other suggestions ? Thanks ppl
|
Also will the pressure switches and fluid change stop the "stuttering" or will it just help the transmission from going bad ?
|
I'm guessing you did not read the links provided....
|
Yess
thanks "i hate cars". i read the links, flushed the tranny and orderd the sensors. sence then the car does not shutter/shake anymore and i will assume it will ony get better w the new sensors. the porduct ID for the sensors i orderd are 28600-RAY-003 and 28610-RAY-003. along w that i orderd 2 gaskets (10MM). i beleave they are the right ones. thanks again you are the man, couldnt of done it w out you :thumbsup:
|
Yup, those are the ones I ordered as well. I think 2610 is the 3rd and 2600 is the 4th if i remember correctly.... They are color coordinated though so just match up the gray with the gray sensor and the brown with the brown. Thats what i did, after I called Acura to get confirmation. I ordered online and they didn't specify which was which on the packaging.
|
Why the hell so many failures under 100k? Are people just beating up on their cars?
|
Originally Posted by Acutron
(Post 12732810)
Why the hell so many failures under 100k? Are people just beating up on their cars?
|
car runs better then ever, tranny feels tight and shifes stronger in lower gears since the new sensors. flush fixxed the shutter. feels solid. thanks for the help people, couldnt of done it w out you. dealership first told me i needed a whole new tranny..haa :yes:
|
Glad it worked for you.:thumbsup: Now if only Acura would listen...
|
All times are GMT -5. The time now is 12:16 PM. |
© 2024 MH Sub I, LLC dba Internet Brands