CalHal1524 |
12-30-2011 09:29 PM |
wonder if it is like my MDX. A tech bulletin apparently blames owners for spilling sticky substances in the slot and will not warranty the repairs. However, mine had no substance and the replaced it. The tech said there is a clip on the spindle that holds the armrest in. Remove the clip, slide the armrest towards the drivers side, and pull out the armrest. then you can remove the 2 screws on the bottom after pulling out the fascia bracketing the cup holder (careful not to break the fascia brackets) and use a screwdriver to hold down the upper locking tabs. The repair was warrantied so I have no direct knowledge of this actually working.
|