Parts list is complete( Finally). There were a few Misc parts i left out like some bolts. I got most of them either from using the parts list
HERE Or i went to my local hardware store (used Grade 8s to be safe)
Engine. J32A2 If needing a new engine look for a CLs-6 motor (if not see below *)
03 CLs-6 speed manual.
03 CLs-6 Manual Engine Harness.
32110-PGE-A11
03 CLs 6 speed ECU
03 CLs-6 Flywheel
22105-PGE-305
03 CLs-6 Flywheel bolts (Qty 8)
90011-PGE-000
03 CLs-6 Clutch Assembly
22105-PGE-305 (unfortunately right now there arent many options for aftermarket clutches)
03 CLs-6 Rear Engine mount and bracket
50810-S3M-A01, 50827-S3M-A00, BOLT (m12X25) 90166-S3M-A00
03 CLs-6 Rearand Front Engine Dampenerand bracket (i would reccomend aftermarket here)
03 CLs-6 Shifter and cables.
54100-S3M-A01, 54310-S3M-A01
03 CLs-6 Starter
31200-PGE-A11 (try to locate used, its expensive)
03 CLs-6 Gauges
03 CLs-6 Hydraulic Clutch lines.
46960-S3M-A01, & 46970-S3M-A01
03 CLs-6 Trans mounts (2 of them)
50806-S3M-A03, 50805-S3M-A03
03 CLs-6 Cup Holder
77230-S3M-A01ZA
03 CLs-6 Parking brake
47105-S3M-A04ZA and to go with it,
Spring
47537-671-670, Nut
47522-594-000, Equalizer pin
47365-538-000, Equalizer
47360-SB2-000
*If you use the J32A2 from the Auto you will need these parts (all from the CLs-6)
Front cam pulley
14260-PGE-A11
Front plate assembly (behind cam pulley)
11860-PGE-A10
Timing belt pulley(lower)
13621-PGE-A11
Crank shaft sensor
37500-PGE-A11 (this little shit costs $500.00)
Subharness for CKP
37501-PGE-A10
TDC Sensors (Qty 2)
37840-PGE-A11
TDC SUB HARNESS
37841-PGE-A10
If you dont already have the Type-s you will want the IMRC
37850-PGE-A01
Brake/Gas pedal assembly from either the accord or CLs-6. (i modified mine)
If you decide to buy it new BRAKE PEDAL ASSY
46600-S3M-A51
Clutch pedal. (this can be from a few cars, i took mine from a 90s civic. it was almost a direct bolt in.
It uses 3 points to bolt in only 2 lined up. I modified a bolt and shim to make it bolt up in the 3rd spot)
If you decide to buy it new you will need the pedal and mount CLUTCH PEDAL
46910-S3M-A01 & CLUTCH PEDAL BRACKET
46990-S84-A01
MASTER CYLINDER ASSY
46922-S3M-A01 & Clutch Fluid Tank
46965-S5A-013, & Clutch Hose
46961-S3M-A02
(i used the one from the civic i pulled the clutch pedal out of)
Things im not sure if you will need but i bought.
Relay box assembly (under hood)
38250-S3M-A21
Shift Boot
83414-S3M-A01ZA
Shift Knob
54102-SL0-023ZB
If you have a header you will either have to have the XS header or COmptech header for the manual. Other wise it wont fit
You will be able to reuse the stock manifolds
If you already ahve a Type-s you MAY Not need these????
Right side cabin to engine comp harness
32100-S3M-A12
Left side cabin to engine comp harness
32120-S3M-A20
I Would attempt with out (that i bought and used with out trying without first) It will make not having to do all the rewiring of
that i did.
Upper instrument harness
32117-S3M-A31
Lower dash harness
32150-S3M-A32